The armed and exit lights will illuminate.Enter your 4 or 6 digit user code to arm the system.The security system will not arm if the ready light is not on or flashing. Ready light will be on or flashing when all protected zones and sensors are secure.Resetting Smoke Detectors To Reset smoke detectors: Press and hold until keypad beeps. If your battery is low, it will either need to be disconnected or replaced. When the battery is low or dead in an old alarm system, the system will start beeping to alert you that it needs to be replaced. Most alarm systems have a backup battery that kicks in if the power ever goes out. When finished, press the key to return to the code entry system. To bypass or unbypass a specific zone, press the key while that zone is displayed. At this point, your keypad should stay silent and your alarm memory should reset. After completing this step, press the “asterisk” key (*) followed by the “7” key. To reset your alarm’s memory, first disarm your system if it is currently armed. Press the key again to exit group bypassing.
0 Comments
Leave a Reply. |